Fire Hydrant Testing in Stalybridge

Why Do You Test Fire Hydrants?

Fire Hydrant Testing in Stalybridge is done regularly to make sure that they can supply water at an acceptable flow rate and be at the pressure they need to be at. If they are faulty and have not been tested it could stop the fire service from doing their job, which runs the risk of property damage, injury, and death.

What Pressure Should A Fire Hydrant Be Tested At?

Fire Hydrant Testing in Stalybridge should be carried out to make sure that when a fire hydrant is flowing, the constant pressure is 20psi, in order to make sure that water is readily available for firefighting and cannot be contaminated by the public water supply. The static pressure of a fire hydrant (when water is not flowing) should also be tested, and this pressure should be less than 40psi.

How To Perform A Fire Flow Test?

Fire flow tests, or Fire Hydrant Testing in Stalybridge, involve many steps. First, is a visual inspection of every part of a fire hydrant that can be seen above ground. Then, below ground, the hydrant and its chamber must also be visually inspected. All faults and repairs needing to be made should be reported immediately. Following this is a wet test, a pressure test, and finally, a flow test, which checks the volume of the water.

How Often Should You Flush A Fire Hydrant?

A fire hydrant should be flushed 1-2 times a year, at the same times that Fire Hydrant Testing in Stalybridge is taking place, in order to make coordination easier. Furthermore, this means that the flushing will be taken care of, and the hydrant will not need flushing, nor will anything be faulty or in need of repairs/replacement, should the fire service need to use it.

What Is The Minimum Pressure Required For A Fire Hydrant?

Fire Hydrant Testing in Stalybridge should be tested at maximum pressure, producing a minimum of 1,125 litres of water every minute at a minimum pressure of 5.25 kgf/cm². At most, the fire hydrant should be able to withstand delivering 150% of its maximum working pressure for at least 2 hours.